STERIS Business Systems

Adding a New DART Test A DART test (Daily Air Removal Test) evaluates the performance of a prevacuum sterilizer by confirming there is adequate air removal...

Deleting a DART Test When a DART test is no longer needed, perform the following steps to delete it. This permanently removes the test from the ConnectCare...

Updating an Existing DART Test If you need to change the information assigned to a DART test, perform the following steps. Typical reasons to reconfigure a...

Adding a DART Warm-Up Task DART Warm-Up tasks are defined when a DART test is created. The fields that define the DART Warm-Up task are shown in the figure...

Adding a New Leak Test A Leak test verifies that a sterilizer is functioning properly. It checks for vacuum leaks in the piping and door seals to determine...

Deleting a Leak Test When a Leak test is no longer needed, perform the following steps to delete it. This permanently removes the test from the ConnectCare...

Updating an Existing Leak Test If you need to change the information assigned to a Leak test, perform the following steps. Typical reasons to reconfigure a...

Creating a Leak Test Report You can create a Leak Rate Test report anytime or have the report sent to you automatically on a weekly basis. The report provi...

Changing the Status of a Task Manually The status of a task is automatically entered into the ConnectCare service portal. However, you can change the statu...

Manage Account Screen (Operator Assistant tab) The Operator Assistant tab displays a list of scheduled tasks that need to be performed by your company’s te...